These are the item needed to make LDR lighting:
Procedure:
1) Solder the components according to the circuit diagram
2) Then decide where to put the LED light. Use long jumper wires to connect the circuit to the LED light.
3) Drill some holes on the body of the remote control car and screw in some stands.
4) Screw the circuit board so it would not move around
5) Finally , connect it to a power sourse (12 volt) and test it
if its bright the LED does not turns on
if its is dark (i cover the LDR sensor with hand) the LED turns on
No comments:
Post a Comment